Opel Vectra A

since 1988-1995 release

Repair and operation of the car

Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13:10. Central console
   13:11. Submode switches
   13:12. Electronic control device (ECU)
   13:13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13:14. Hoses and tubes of a radiator of cooling of transmission liquid
   13:15. Replacement of sealing rings of differential
   13:16. Sensor of temperature of transmission liquid
   13:17. Sensors of speed of rotation of entrance and output shaft
   13:18. Removal and installation of the automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions

13:15. Replacement of sealing rings of differential

Removal

PERFORMANCE ORDER

1. Sealing rings of bearings of differential can be replaced on the transmission installed in the car.

2. In the presence take off a cap from a forward wheel, then weaken bolts of fastening of a wheel. Tighten the emergency brake, then lift a forward part of the car and record on supports. Unscrew bolts and remove a forward wheel.

3. Take the forelock, then unscrew the koronchaty nut fixing the spherical hinge connecting the lower lever from a resistant forward suspension bracket.

4. Using a stripper of spherical hinges, squeeze out a pin of the spherical hinge.

5. Merge transmission liquid.

6. Having pulled a nave of a forward wheel outside, take the internal end of a power shaft from differential. Using a soft wire, tie the internal end of a power shaft to a body.

7. Using a screw-driver edge as the lever, take a sealing ring from differential.

Installation

PERFORMANCE ORDER

1. Grease working edges of a new sealing ring with gearbox oil, then, using a tubular mandrel of the corresponding diameter, establish a new sealing ring in a differential nest.

2. Establish in a flute on the internal end of a power shaft a new lock ring and insert a power shaft into differential.

3. Install the spherical hinge connecting the lower lever of a forward suspension bracket from a resistant suspension bracket and screw a koronchaty nut on a pin of the hinge and tighten it the required moment. Insert the new forelock fixing a nut from unscrewing.

4. Establish a wheel, then lower the car on the earth and finally tighten bolts of fastening of a wheel. In the presence establish a wheel cap.

5. Fill in oil in the transmission.