Opel Vectra A

since 1988-1995 release

Repair and operation of the car



Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
- 18. Electric equipment
   18.2. General information
   18.3. Electric chains
   18.4. Detection of a faulty chain
   18.5. Safety locks and relay
   18.6. Ignition lock
   18.7. Switch of lighting and indexes of turns
   18.8. Windscreen washer/screen wiper switch
   18.9. Switches on the dashboard
   18:10. Switch of adjustment of provision of an external mirror
   18:11. Switch of the electric drive of the hatch
   18:12. The switch of illumination of salon installed in a door rack
   18:13. Switch of lighting of the luggage compartment
   18:14. Stoplight switch.
   18:15. Switch of a control lamp of the emergency brake
   18:16. Oil pressure sensor
   18:17. Lighter illumination
   18:18. Hours
   18:19. A front seat with heating
   18:20. Combination of devices
   18:21. Elements of a combination of devices
   18:22. Elements of the on-board computer
   18:23. Elements of a control and management system
   18:24. Sound signal
   18:25. Lamp of illumination of salon
   18:26. Replacement of bulbs of internal lighting
   18:27. Headlight
   18:28. Engine of the proofreader of light of headlights
   18:29. Adjustment of light of headlights
   18:30. System of reduction of intensity of light of headlights
   18:31. Forward index of turns
   18:32. Side repeater of turns
   18:33. Forward fog light
   18:34. Back lamps
   18:35. Lamp of illumination of registration plate
   + 18:36. Replacement of bulbs of external lighting
   18:37. Replacement of brushes of a screen wiper
   18:38. Screen wiper levers
   18:39. Washer jets
   18:40. Engine and drafts of a screen wiper
   18:41. Engine of a screen wiper of a back door
   18:42. Headlight screen wiper engine
   18:43. Windscreen washer tank
   18:44. Windscreen washer pump
   18:45. Unidirectional valve of a washer of headlights
   18:46. Elements of window regulators with the electric drive
   18:47. Programming of a control system of window regulators
   18:48. Elements of the central blocking of doors
   18:49. Antenna
   18:50. An antenna mast with the electric drive
   18:51. Loudspeakers
   18:52. Radio tape recorder
   18:53. Hatch drive electric motor
   18:54. Speedometer drive cable
   18:55. Anticreeping alarm system
   18:56. Elements of the anticreeping alarm system
   18:57. Safety cushion
   18:58. A safety cushion from the driver
   18:59. A steering wheel with a safety cushion
   18.60. Contact block of a safety cushion
   18.61. A safety cushion from the passenger
   18.62. A safety cushion arm from the passenger
   18.63. Control unit of safety cushions
   + 18.64. Electric circuits
+ 19. Check of malfunctions


24bec775


18:46. Elements of window regulators with the electric drive

GENERAL INFORMATION

Prevention

After removal and installation of any element of window regulators with the electric drive it is necessary to program system of window regulators.


Remove a weight wire from the accumulator.

THE SWITCHES INSTALLED ON THE DOOR

Removal

PERFORMANCE ORDER
1. Using an edge of the thin screw-driver as the lever, remove a decorative slip from the internal handle of opening of a door.
2. Using an edge of the thin screw-driver as the lever, take the switch from a nest and disconnect from it the electric socket.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

THE SWITCHES INSTALLED ON THE CENTRAL CONSOLE

Removal

PERFORMANCE ORDER
1. Switches are removed as uniform knot. If one of switches is faulty, it is necessary to replace the block of switches.
2. Remove a back part of the central console.
3. Release clamps and take the block of switches from the top part of the central console.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.

LEKTRODVIGATELI OF THE DRIVE OF WINDOW REGULATORS

Arrangement of nuts of fastening of the electric motor of a window regulator of a forward door and screw of fastening of the block of impulses

PERFORMANCE ORDER
1. Remove a window regulator from a door.
2. For removal of the electric motor from a window regulator of a forward door unscrew three nuts, the fixing electric motors and the screw which fixes the block of impulses to a window regulator. Remove the electric motor with the block of impulses. Keep in mind that if the electric motor or the block of impulses are faulty, their replacement needs to be made in collecting (see the drawing).
3. The electric motor of the window regulator established in a back door is an integral part of a window regulator.