Vektr's Opel And
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
- 5. Cooling system
5.2. General information
5.3. Antifreeze
5.4. Washing of the cooling system
5.5. Discharge of cooling liquid
5.6. Filling of the cooling system
5.7. A radiator (models with the mechanical transmission)
5.8. A radiator (models with the automatic transmission)
5.9. Check and cleaning of a radiator
5.10. Thermostat
5.11. Check of operability of the thermostat
5.12. Water pump
5.13. Radiator fan
5.14. Broad tank and sensor of level of cooling liquid
5.15. Sensor of the index of temperature of cooling liquid
5.16. Radiator fan thermal sensor
5.17. Control panel of a heater
5.18. Heater radiator
5.19. Heater fan engine
5.20. Ventilation nozzles
+ 6. Fuel system
+ 7. The fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of decrease in toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrical systems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions
|
Removal
Detachment of the electric socket from the sensor of the index of temperature on models of 1,6 l
Arrangement of the sensor of the index of temperature on models of 2,0 l of SOHC
Arrangement of the sensor of the index of temperature on models of 2,0 l of DOHC
| PERFORMANCE ORDER |
| 1. On l models 1,4 and 1,6 except C16 NZ2 the sensor is screwed in in an inlet collector, and on the l C16 NZ2 models 1,8 and 2,0 the sensor is screwed in in a thermostat casing (see rice. A detachment of the electric socket from the sensor of the index of temperature on models of 1,6 l, the Arrangement of the sensor of the index of temperature on models of 2,0 l of SOHC, the Arrangement of the sensor of the index of temperature on models of 2,0 l of DOHC). |
| 2. Partially merge cooling liquid from the cooling system. |
| 3. Remove a weight wire from the accumulator. |
| 4. Disconnect the electric socket from the sensor, then unscrew the sensor. |
|
Installation
Installation is made in the sequence, the return to removal taking into account the next moments...
| PERFORMANCE ORDER |
| 1. Before a vvinchivaniye of the sensor apply a thin film of sealant on a sensor carving. |
| 2. Fill in cooling liquid in the cooling system. |
| 3. In conclusion start the engine and check operation of the sensor of the index of temperature. Check the cooling system for existence of leaks. |
|
|
|
